Ok, so I recently just randomly installed some stuff to check my processor's temperature and when idle, it was at like 68 C. Holy crap. I was like wth. When I start a program or a game, it goes to round about 78. But thats it. It stays there. I checked the temperature at BIOS and it shows the same.
This leads me to think either the heatsink isnt on the processor properly. I did put the fan on it once more after unscrewing it. I think I got it right but the stupid thermaltake fan/heatsink has plastic screws which really are a pain in the ass.
So I check the temperature again and its the same. Any ideas how to solve this particular problem? It's strange though cause the computer runs pretty okay. Fans are loud but that's pretty much it. One thing to note would be that my previous board's processor connector plug or outlet on the mobo burned down. Could it be because of that, that the processor is damaged or something? It shouldnt work at all if it was damaged right?
My new rig has 5 fans, all of them running. The BIOS shows only one for some reason. I dont know, I'm kind of lost here. Should I go out and buy a new processor fan/heatsink or should I just buy a new processor? Or is it the mobo?? So lost.
Yeah, better cooling system. I don't think buying another processor would make a difference, unless it was flawed when it came out of the factory (but that's unlikely considering Intel or AMD's strict standards). Check the wiring and ventilation too.
Disclaimer: Any sarcasm in my posts will not be mentioned as that would ruin the purpose. It is assumed that the reader is intelligent enough to tell the difference between what is sarcasm and what is not.
Its an old processor, Pentium (R) 4 CPU 3.00 Ghz. Its single core I think but HT enabled. I dont know, does it have a name like motherboards? Where do I find that?
Muz, I said that the processor was a mobo whose processor connector burned. Would that have a chance of making the processor faulty?
Also, I'm thinking the sensors on this mobo might be faulty themselves as the computer functions okay. Not great but okay.
I'm pretty sure that temperature is waay too high. Normally you'd want it at about 50-60. You might try a different cooler. I just so happen to be running on a Pentium4 based computer temporarily - i can check the temperature when i get home.
Well, for an old hot Pentium 4 3Ghz, that sounds about right for an idle temperature. And you're right, a lot of times measuring equipment can be way off.
Is the utility you installed this? http://www.intel.com/design/motherbd/active.htm It will warn you if your certain processor is too hot. Oh and also--where is your computer? Is it in one of those desk cabinets or up against a wall? Even with all the fans in the world, if the air can't get anywhere, it will still be hot.
I'd say, if you're really worried about it, try to ventilate the system differently. (Also run it with the cover off to see what it's like with maximum ventilation) But I think as long as you don't get an overheat error on bootup, you should be ok.
If you're feeling really adventuresome, you could experiment with some water cooling systems.
my old processor was running at about 70 under load which was far too high, i was running it with no thermal paste though
some processor's surfaces are slightly concave or convex which can often be the problem (solved usually by decent thermal goop or lapping!) as the heatsink has to set FIRMLY on the heat plate. my current rig doesnt have a case at all and it runs cooool
Oh also, it could very well be a funky power supply. If you have any extra one laying around that's compatible, give it a try.
Do what Mr. Pineapple said and make sure the heatsink is firmly attached to the CPU. I seem to recall reading about a certain connector that made two distinct clicks before you knew the heatsink was connected properly. Could be unrelated though.
yeah if memory serves (it has been a few years now) if its a 3ghz P4 its likely to be a socket 775. Their standard heatsinks need clicking in at the corners the last one always requires more pressure than i'd like to put on a circuit board but there you go.
My processor out of no where, started reaching well over 100'C and my PC would actually shut down because of too much heat. I just went in and changed the thermal paste and everything was good again.
If I watch a youtube vid for about 10 minutes my laptop overheats and shuts down, followed by funky "spllzzzzzzzzzzzzzzzllllllllzzzzzzzzzz" noises while booting up.
Just popped on to say my old laptop was a 3.06ghz P4 with HT. They really were hot potatoes. Much too hot to put in my bag after doing heavy duty work on it. 60c sounds kinda normal. My MB is currently at 40c and that's in a tight arse metal case. 60 sounds okay.
Most cheap electronics are designed to run reliably only up to 70 degrees centigrade. Processors may or may not contain cheap electronics. They're advanced tech, but still transistors. 60 is a bit too close for comfort; it'll heat up even more when doing heavier work.
Disclaimer: Any sarcasm in my posts will not be mentioned as that would ruin the purpose. It is assumed that the reader is intelligent enough to tell the difference between what is sarcasm and what is not.
they usually have temperature guidelines in the manual and such like... i remember my old athlon XP-M monster could "apparently" run at up to 100 degrees..... obviously i'd never run anything that hot, but its interesting to see how different brands have their own max running temps..... basically to cut a long story short, look it up. They all have a max temp!
Advertisement
Post Reply
If I watch a youtube vid for about 10 minutes my laptop overheats and shuts down, followed by funky "spllzzzzzzzzzzzzzzzllllllllzzzzzzzzzz" noises while booting up. 
